Jump to content

Recommended Posts

I peeled off the original label. It was a pain but I didn't want it to show through. I also ended up peeling off the part that was on the cap, too. I figure that people only have to open it to see that it wasn't used!

Share this post


Link to post
Share on other sites

I peeled off the original label. As for the new ones I made sure they overlapped a little so they stuck together instead of just to the plastic tube.

Share this post


Link to post
Share on other sites

I also overlapped the edges. I did notice that the edge was still coming up a bit though, so I might try the packing tape idea. Thanks for sharing that tip!

Share this post


Link to post
Share on other sites

I did have to trim the label a bit to fit perfectly so as to not cover the safety seal. Then I just cut the packing tape to fit. I was concerned that without the packing tape they wouldn't be waterproof and would get ruined quickly.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×